It is suitable for testing equipment for compressive strength preparation of industrial and civil building wall tiles. Be sure to read the instructions carefully before use. It is operated by professional experimenters to avoid injury caused by improper operation. For more information, please contact our customer service staff. According to GB/T 25044-2012 "General requirements for wall-mounted brick compressive strength sample preparation equipment" technical design and production of new strength test mixing equipment. It is a special equipment for mixing pulp. The control system adopts program-controlled frequency conversion technology, which has the advantages of continuously adjustable speed, digital display, beautiful appearance and convenient operation.
★搅拌转速：（分为三个档）I 档 45r/min II档 90R/min III档 150r/min
Second, technical parameters:
★Using the relative motion between the mixing arm and the mixing pot to test the compressive strength of the masonry brick.
★Rated voltage: 380V
★Stirring pot rated capacity: 23.6L
★ mixing capacity; 20L
★Rated frequency: 50HZ
★ rated power: 2.5KW
★ Mixing speed: (divided into three gears) I gear 45r/min II gear 90R/min III gear 150r/min
★ Weight: 100kg
Third, the operating procedures:
Put the mixer on the horizontal workbench before use, connect the mixer to the power supply of the operation cabinet, then press the start switch and slowly rotate the speed control switch, and the stirring starts.
★ Read the instructions carefully before use and strictly follow the operating procedures.
★The grounding wire device must be connected before starting the machine. A can be removed at will during operation to avoid electric shock.
★ When the machine is working, the hand is not allowed to reach into the mixing pot to avoid accidents.
★ If the machine is found to be faulty, stop it immediately and look for a professional check.
★ After the mixing is completed, the drum and the mixing blade are removed, cleaned, and stored dry.
★ Mix the pot and disassemble it. It must be handled gently when it is installed, so as to avoid the deformation of the bumper.